The Masters Golf Extension Piece Double End is an essential club-repair and custom-fitting tool designed for club builders, fitters, and golfers who want to increase the playing length of their steel-shafted clubs without replacing the entire shaft. Engineered specifically for steel shafts with a .580" butt diameter, this double-ended piece lets you extend not one but two clubs from a single unit — simply cut it in half to produce two ready-to-use extensions. Whether you are fitting clubs for taller players, restoring a shaft that was trimmed too short, or fine-tuning your set for optimal performance, this extension piece delivers a precise, secure fit at a fraction of the cost of a full reshaft.
The extension piece features tapered (swedged) ends on both sides of a parallel mid-section. When you cut the piece in half at the centre, each half becomes an individual extension with one tapered insertion end and one exposed butt end. The tapered portion slides securely into the existing steel shaft butt; the exposed portion protrudes beyond the shaft, adding the desired extra length. Once the epoxy has fully cured, simply trim the exposed end to your precise target length before re-gripping.
Note: Extending a club by more than 2 inches (approx. 50 mm) may compromise shaft integrity and increase the risk of breakage. Always observe recommended extension limits.
| Specification | Detail |
|---|---|
| Product Code | SEXPZ |
| Brand | Masters Golf |
| Shaft Compatibility | Steel shafts with .580" (0.580") butt diameter |
| Design | Double-ended (extends 2 clubs per piece) |
| Total Length | Approx. 30.5 cm (12") |
| Butt Diameter | .580" |
| Recommended Max. Extension | Up to 2" (approx. 50 mm) per club |
| Installation Method | Shafting epoxy + cut to length |
| Category | Club Servicing / Shaft Extensions |
| Suitable For | Irons, hybrids and other steel-shafted clubs |
No additional properties are available for this product.
Your review will help us and other customers when buying this product.
