Extending any golf club to the perfect playing length is quick and straightforward with the Masters Golf Graphite Shaft Extender in Standard size. This single-use plastic extension piece is designed for golfers and club-builders who need to add length to a graphite-shafted club without replacing the shaft entirely. Whether you are customising a club to suit a taller player or salvaging a shaft that has been trimmed too short, this extender delivers a reliable, permanent solution using standard epoxy adhesive.
Before installation, measure the inside diameter (ID) of the shaft's butt end. Most graphite shafts have a .600" outer diameter, but the inner diameter varies depending on wall thickness. The Standard extender is made for shafts with a standard, thicker inner wall. If in doubt, take the club to a club-fitting professional who can measure with calipers.
Mix a suitable golf-club epoxy adhesive according to the manufacturer's instructions. Apply the epoxy to the ribbed or fluted section of the extender — the grooves help the epoxy fill evenly and create a strong mechanical bond. Slowly rotate the extender as you slide it into the butt end of the shaft to ensure full epoxy coverage.
Wipe away any excess epoxy and allow the bond to fully cure — typically 24 hours for standard golf epoxy, though follow the instructions of your specific adhesive. Once cured, cut the extender down to the desired playing length using a shaft-cutting tool or pipe cutter. Finish by re-gripping the club as normal.
Extending a graphite shaft by more than 2 inches can negatively affect the shaft's flex profile and structural integrity, increasing the risk of breakage during the swing. For best results and safety, keep extensions to 2 inches or less. The Oversize variant of this extender is also available for shafts with a thinner inner wall — confirm your shaft's ID before ordering.
Masters Golf offers this graphite shaft extender in two variants to cover the full range of graphite shafts on the market:
Because shaft inner diameters are not always published by manufacturers, it is strongly recommended to measure the inside diameter of your shaft's butt end with a caliper — or have it measured by a professional club-fitter — before placing your order.
| Specification | Detail |
|---|---|
| Brand | Masters Golf |
| Product Code | SEXPG |
| Variant | Standard |
| Compatible Shaft Type | Graphite shafts (standard / thicker inner wall) |
| Extender Length | 5 inches |
| Material | Plastic |
| Quantity per Pack | 1 piece (extends 1 club) |
| Installation Method | Epoxy adhesive (sold separately) |
| Maximum Recommended Extension | 2 inches |
| Typical Shaft Butt Outer Diameter | .600" (verify inner diameter before ordering) |
| Also Available As | Oversize variant (for thinner inner wall shafts) |
No additional properties are available for this product.
Your review will help us and other customers when buying this product.
